MRX-2 4WD setting sheet MUGEN SEIKI Ver.9903
| MRX-2 4WD set up sheet MUGEN SEIKI Ver.9903 | |||
| Name： | Date： / / | Track： | |
| Engine： | Piug： | Fuel： | Body： Body
Position Rear spoiler： mm |
| Head clearance： mm | Muffler： mm | ||
| Clutch bell clearance： 0.5 mm | |||
| Clutch spring adj. nut： 0.9 mm | |||
| Track condition: | |||
 |
Front rebound stop | +2 mm | mm | mm | mm |
| Rear rebound stop | +7 mm | mm | mm | mm | |
 |
Front damper piston | Stock | |||
| damper oil | #400 | ||||
| spring | Stock | ||||
| spring adj. pos. | mm | mm | mm | mm | |
| Front track width | 252 mm | mm | mm | mm | |
| road clearance | 7 mm | mm | mm | mm | |
| camber angle | -1° | ||||
| toe | 0° - out | ||||
| anti-sway bar |  |
 |
|
|
|
| upper arm pos. | 2 mm | mm | mm | mm | |
 |
Rear damper piston | Stock | |||
| damper oil | #400 | ||||
| damper position | 1 | ||||
| spring | Stock | ||||
| spring adj. pos. | mm | mm | mm | mm | |
| Rear track width | 262 mm | mm | mm | mm | |
| road clearance | 8 mm | mm | mm | mm | |
| camber angle | -2° | ||||
| anti-sway bar | Stock | ||||
| toe-in | 0.5° - 1° | ||||
 |
Front tire type | ||||
| tire dia. (start) | L68.5/R68.5 | L /R | L /R | L /R | |
| tire dia. (finish) | L /R | L /R | L /R | L /R | |
| Rear tire type | |||||
| tire dia. (start) | L76/R76 | L /R | L /R | L /R | |
| tire dia. (finish) | L /R | L /R | L /R | L /R | |
| ２speed gear 1st. | / | / | / | / | |
| 2nd. | / | / | / | / | |
| Roll-cut 1st. | mm | mm | mm | mm | |
| 2nd. | mm | mm | mm | mm | |
| Pulley A (25 or 26) | 26 | ||||
| Over drive ratio | 0.998 | ||||
| Track traction | % | % | % | % | |
| Result | |||||
| Best lap time（１Ｌ） |
： mm